Home Home Home Home Home Home Home Home
Lame cromate per taglio di cornici
Lame cromate per taglio di cornici
Lame cromate per taglio di cornici
Lame cromate per taglio di cornici
Lame cromate per taglio di cornici
Lame cromate per taglio di cornici
Lame cromate per taglio di cornici
Lame cromate per taglio di cornici
Lame cromate per taglio di cornici
Lame cromate per taglio di cornici

Lame cromate per taglio di cornici

285.5

Dettagli

CMT XTREME BALANCING™

 
Each blade undergoes rigorous assessment and only in the event that micro imbalance is detected will the appropriate correction holes be applied.
You may find 1 to 5 micro balancing holes on your blade, depending on the degree of micro imbalance (fig.1). When in perfect balance, a single incision will appear on
the blade as proof of balance.
These holes will have no effect on the technical properties of the blade during use (such as an increase in noise**, chip build-up at the correction site, etc.).

This translates to precise cutting, longer blade life, reduced vibration and noise, and less wear and tear on your machine components.


**Results are based on tests conducted by an independent laboratory.
Check out the results
Varianti
Filtra varianti
Codice D B FT Z K P α β
285.580.10M
285.580.10M 250 30 COMBI3 80 3 2.5 10 ATB 20
285.596.12M
285.596.12M 300 30 COMBI3 96 3 2.5 10 ATB 20